ad: L-HROutlet
ad: l-rl
ad: l-assoc
ad: Subscribe
LA7THA Norway flag Norway

Login is required for additional detail.

Email: Login required to view

Ham Member Lookups: 14077



QRZ.com update 17th February 2015

Some updates after moving to new QTH. I have done all my Radio and DX effort from the North west coast from 1991 until last summer (2014). My previous qth was surrounded by 3000 to 4000 feet high mountains I all directions, however I managed around 300 DXCC worked from that location. I was also using a remote station located approx. 15km from my home that worked pretty well.

Since summer 2014 I have built and prepare my new QTH, this is located approx. 30 km south of Oslo on the country side. This QTH is by the farmers a pretty quiet area. So far I got the shack in place and my OB15-7 Yagi is mounted on a self-supporting mast @ hight of 18.5-19 meters.

I have also installed a SAL30 receiving antenna for Low band purchased from Array solution, the brain behind this antenna is Mark Bauman KB7GF. I have a kind of homemade approach to my installation, this since the antenna needs to be installed @ hight of 8-10 feet due-to deer and moose.

Working DX from this location is in most cases easy peacy, however low band is always a struggle as “normal”.  The current low band antenna is end feed dipole using wire for top and bottom loading. Antenna total height is 26-27 meter where 23-24 meter is active element. Feed impedance is around 20-25 ohm, I feed this with  ¼ wave transformers mad of ¼ wave 50ohm RG213 and  ¼ wave RG11 75 ohm coax in parallel. Result of this is a ¼wave 29 ohms coax. From the end of my ¼ transformer to the shack I run a full wave length of RG11, seems to fit with the distance. I would like to change the full wave length of RG11 with a better coax, however seems that this will cost me 1000US dollars, Surplus heavy duty coax is not so common in Norway. See some of my new pictures below.

All for now,

73 de Rune (Ron) LA7THA


None radio relevant stuff:

LA7THA was created 1967 :-), I grew up in the North West coast not so far from the City Aalesund. My local town is Oersta about 60 Km south east from Aalesund. Had different jobs for a while then couple of years with electronics.

After school I start working at Unicom AS, mainly building and repairing VHF and UHF radio repeaters. My offshore carrier started in 1998 for Petroleum Geo-Services. http://www.pgs.com/ was offshore for nearly 15 years and then two years ago I start working in the PGS Headquarter office in Oslo.

Done some travelling on my years offshore, this since the vessels where located worldwide. See pictures of one of our vessels in end of page, or go to this link and see some videos.





Mast and antenna ready to be lifted. :-)

4 Ton wich



Finally the antenna and mast is installed


SAL30  receiving antenna project.


Corner of one loop adjusted.


Finally all in place.


160meter end feed vertical, wire loaded dipol.


Toploading wire


Vertical explanation.


My location / directions N-S-E-W. Pictures taken before antennas was insatlled.



Approx antenna location.


Work related pictures.




7135549 Last modified: 2016-03-03 17:00:49, 5095 bytes

Login Required

Login is required for additional detail.

You must be logged in to file a report on this page

Please login now...

QRZ Logbook Summary for - LA7THA

This callsign does not participate in the QRZ Logbook

ad: giga-db
Copyright © 2018 by QRZ.COM
Sun Feb 18 18:38:14 2018 UTC
CPU: 0.051 sec 62898 bytes mp